Industrial boilers
Product thermal capacity: 4-35 t/h
Working pressure: 1.0-2.5 MPA
Outlet temperature: 184-350 ℃
Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil
Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries
retrofit of heating boiler have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
retrofit of heating boiler.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
The low NOXAireJet, DAR-4Z burners are used and OFA nozzles in dual air zone are installed in low NOXretrofit of opposed firing boilers of 3
The advanced development of our time-tested burnermonitors all thermal processes and your boiler Retrofit with best available technology The SAACKE
Cogeneration Retrofit Systems for large to small gas and diesel engines that save energy and money.
Based on a 600 MW subcritical, tangentially-firing boiler after low NOx burner retrofit in the operation of the problems(such as the outlet steam
The low NOXAireJet, DAR-4Z burners are used and OFA nozzles in dual air zone are installed in low NOXretrofit of opposed firing boilers of 3